| Introduction to Vehicle Electrical Distribution System (EDS) |
| E&E Architecture |
| Electric Schematic |
| Introduction to wiring harness assembly |
| Wiring harness design process for New Product Development (NPD) |
| Introduction to CATIA or Creo electrical workbench |
| Customized settings for electrical environment |
| Wiring harness routing process for CATIA or Creo |
| CATIA or Creo – electrical part design |
| Clip/clamps/support part definition |
| Back shell definition |
| Protective covering definition |
| Preparation of harness assembly |
| Creating the wire harness geometrical bundle |
| Inserting harness components into a geometrical bundle |
| Positioning your inserted electrical parts |
| Connecting & disconnecting electrical components |
| Defining the wiring harness routing |
| Wiring harness routing on external references |
| Modifying the wire harness bundle segments |
| Wire harness protective coverings |
| Use of electrical splices |
| Bundle continuity check/analysis |
| Geometrical bundle warnings |
| 3D annotation |
| Modifying the wire harness bundle segments |
| Modifying the branch point location |
| Deleting bundle segment |
| Bundle continuity check/analysis |
| Geometrical bundle warnings |
| 3D annotations |
| Important commands, tips, & techniques |
| Wiring harness flattening workbench |
| Flattening workbench settings |
| Flattening the 3D harness assembly |
| Modify flatten assembly |
| Saving the flatten files |
| Drawing, creation & contents |
| Wiring harness component specifications & selection parameters |
| Available suppliers in the market (India) |
| Definitions |
| Routing & packaging process |
| Design criteria (generic) for wiring harness |
| Packaging rules & best practices |
| Guidelines for battery cables routing |
| Clearance management |
| Water ingress protection |
| Thermal protection management |
| Chaffing protection |
| Vibration protection |
| Routing on/near dynamic parts (engine, wheel) |
| Harness bending rules (harness & battery cables) |
| Interconnection connector parking |
| RH/ LH Door Pannel wiring harness |
| Front Bumper wiring harness |
| Instrument panel wiring harness |
| Chassis System wiring harness |
| Wire Harness 3D Routing – Software CATIA or Creo, Design Guide line, wire selection, routing, connector & clip selection, Testing of wire harness etc. |
| Capital Harness Design – library creation, Harness drawings, simulation of schematics for voltage drop, fuse blown, short circuit, green report etc., interface between these tools with 3D, ensure quality of drawings / reports in the tool. |
| Sr No. | Course Title | Duration (Hrs.) | Syllabus |
|---|---|---|---|
| 1 | CATIA V5 and Creo 10.0 electrical wiring harness with Capital Harness design | 4 Months | Download |
